Knowledge of Nail Art (Full Coverage Nail, Half Coverage Nail, Light Coverage Nail)

1、Full coverage nail tips

1、Polish Nail Surface.

Can be used to rub the end of the strip, up and down the surface of the nail, to ensure that the surface of the nail has no reflective points, need to have scratches, in order to make the nail adhesive stick firmly.

2、Choose the right nail tip

Nail piece selection must be wrapped AB point, remember! Rather big than small principle, choose the right nail plate is the most critical part of the paste nail plate, otherwise the back are not good!

• Full coverage of the back edge of the nail tip
• Correctly affixed nail tip AB points
• Misdemonstration

2、Half-covered nail tips

The difference between a half sticker and a full sticker is that the position of the backstop is slightly away from the back edge of the nail, eliminating the steps and then doing the construction to level the nail surface

• Semi-coverage of the posterior edge of the nail tip
• Need to level the nail surface after eliminating steps
• You need to be careful to wrap the AB points.

3、Shallow coverage of nail tips

Shallow sticker nails are thinner than normal nails, so to do the build effect is equivalent to a light treatment extension

• Use quick-drying nail glue
• Sanding steps
• Nail construction will be required after the manicure.

Caution：

1. The same reason with the nail plate with paper tray, need to adjust the shape of the nail, can correct the eagle hook nail and upturned nail, the two sides of the tip can also be cut off to facilitate the paste
2. After construction, it needs to be shaped with shaping clamps and then can be sanded twice, and both sides need to be straightened.

Specific Steps for Shallow Covered Nail Tips

1. nail cut short, trimming nail shape, pay attention to the length of the nails reserved about 2mm

2. front processing (see pre-study notes)

3. carve and grind the nail surface, with the front of the full sticker, half sticker operation consistent, need to have scratches

4. select the appropriate width of the nail piece, use the speed in the nail adhesive pasted on the nail surface

5. Trimming the length and shape of the nail piece.

6. Polish the nail steps

7. Do the construction, shine the light for 5~10 seconds to shape.

Summarize (must see)

1、Full coverage of nail tips

Full sticker nail plate need to pay attention to the rear edge to be adjusted to the appropriate nail backup, full sticker nail plate can be sanded thin backup and then paste, can also be pasted to the surface of the nail in the sanding to adjust steps

2、Half-covered nail tips

Nail salon commonly used patch way, the effect is good, save time, the price is slightly more expensive, you need to use reinforcing gel to find flat nail surface, because the nail piece is hard, so the shaping effect is not obvious, can be adjusted by grinding the width of the nail surface

3、Shallow coverage of nail tips

Shallow sticker nail effect and operation is similar to the light therapy extension, need to stick on the nail to do after the construction of the nail, nail shape is not good when you need to adjust the nail shape when sticking the nail to prevent upward nail and under the hook of the nail, shallow sticker nail is softer, can be used after the construction of the molding clip molding